Owatrol Gelcoat & Surface Restorer Marine Polytrol £19.62
Owatrol Gelcoat & Surface Restorer Marine Polytrol
Gelcoat Restorer is a deep penetrating oil that penetrates deep into gelcoat to re-wet the pigment and so restore the dull, faded look of the gelcoat to its original colour and lustre. It then dries to a tough, long lasting and flexible finish. Gelcoat Restorer eliminates the need for
expensive waxes and polishes that sit on the surface and dry out quickly.
Simple to apply using a cloth or soft brush, it’s ready to wipe off in just 10 minutes! It can be used on both horizontal and vertical surfaces and can even be used on fibreglass (GRP). Gelcoat Restorer dries to a tough and long-lasting flexible finish which does not leave a film – so it won’t peel or flake.
Ideal Uses for Gelcoat Restorer
All surfaces must be clean, dry and free of dirt, grease, grime and mildew. All waxes, polishes, silicone etc. should be completely and thoroughly removed. Treat any mildew with a 50:50 bleach and water solution. Scrub the solution on to the surface and allow it to stand for 10-15 minutes then rinse thoroughly.
Clean the surface with warm soapy water or Deck Cleaner, rinse thoroughly and allow it to dry for a minimum of 24 hours depending on surface.
Application of Gelcoat Restorer
Always work in areas that can be completed 10-20 minutes to ensure an even appearance. If the surface absorbs the Gelcoat Restorer unevenly (i.e. some matt and some shiny patches) move any surplus oil from shiny areas to matt areas. Wipe off any excess Gelcoat Restorer with a lint free cloth before it becomes tacky. For a shinier finish, buff the surface with a lint-free polishing cloth.
First saturate a soft cloth with Gelcoat Restorer and wipe it on. With a soft cloth, wipe off any excess within 10 minutes. Next gently polish with a lint-free cloth to a new sheen.
Note: Gelcoat Restorer is not a surface coating. Its place is in the surface, not on top.
Maintenance is due when a Gelcoat Restorer treated surface shows signs of fading. Prepare and re-treat surfaces as directed above.
Clean any tools used with white spirit. Gelcoat Restorer is non-flammable, however any rags, steel wool etc. soaked in Gelcoat Restorer may spontaneously catch fire if improperly discarded. Rags, steel wool etc must be saturated with water after use or placed in a sealed, water filled metal container, before disposing of them with household waste. Rags may be laid flat and air dried before discarding.
Things to Remember
Cover and protect everything you do not wish to treat.
Apply between +5°C and +35°C.
Do not apply in direct sunlight or on to hot surfaces.
Do not allow excess Gelcoat Restorer to dry and create a film on the surface (always remove excess product).
Do not use Gelcoat Restorer on white surfaces.